Dakota-digital PAC-2700 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Faxe Dakota-digital PAC-2700 herunter. Dakota Digital PAC-2700 User Manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 6
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
MAN# 650264:B
PAC-2700
ELECTRIC COOLING FAN CONTOLLER
GND
SENDER
SW1
IGNITION
FAN LOW
+12v
A/C
FAN HIGH
SW2
CUSTOM
ADJUSTMENT
PAC-2700
FAN CONTROLLER
FAN2
Fan PWR +12V
LOW
FAN1
FAN
HIGH
+12V
Not used in
sender only
application
+12V with key ON
A/C clutch cycle switch
Fused battery 12V
Choose
option
below
SENDER
GAUGE
single fan
two separate fans dual speed fan
Fan
High
Fan
High
Fan
Low
Fan
Low
+12V
NOT
CONNECTED
FAN
Fan
Low
Fan
High
(+12v trigger)
+12V
Fan PWR +12V
Fan
PWR
+12V
IMPORTANT NOTE:
The +12V for the
controller should NOT
be taken from the same
circuit as the Fan Power
12V as this can cause
the fan to cycle on and
off.
Seitenansicht 0
1 2 3 4 5 6

Inhaltsverzeichnis

Seite 1 - Fan PWR +12V

MAN# 650264:B PAC-2700 ELECTRIC COOLING FAN CONTOLLER GNDSENDERSW1IGNITIONFAN LOW+12vA/CFAN HIGHSW2CUSTOMADJUSTMENTPAC-2700FAN CONTROLLERFAN2Fa

Seite 2 - MAN# 650264:B

MAN# 650264:B Operation The electric cooling fan controller provides a way to run up to two electric engine cooling fans or one two speed coolin

Seite 3

MAN# 650264:B Set Up 1. Press and hold SW2, then turn the key on. 2. Release SW2, then press and release SW1 to move onto the next step.

Seite 4

MAN# 650264:B Custom Calibration Note 1: If your engine is warm you may need to disconnect the wire from your sender in order get to the lower

Seite 5 - TROUBLESHOOTING

MAN# 650264:B TROUBLESHOOTING PROBLEM CAUSE SOLUTION Display reads “Er0” (lost memory) Setup memory lost, unit needs to be recalibrated Go thro

Seite 6 - MAN# 650264:B

MAN# 650264:B TROUBLESHOOTING (continued) PROBLEM CAUSE SOLUTION Custom gauge setup displays “Err” and returns to “Snd” setup option Not enough

Kommentare zu diesen Handbüchern

Keine Kommentare